Reply within 1 business dayWhatsApp
Blog

Vacuum Fryer De-oiling: How to Reach 13–20% Oil Content in Chips

LyoFry · Shanghai
Process Know-how3 min readBy LyoFry Engineering Team
Illustration of a vacuum frying line for tropical fruit chips

Short answer: Spin the basket inside the fryer while it is still under vacuum. Releasing vacuum before spinning lets air pressure push surface oil into the product’s pores. With in-vacuum centrifugal de-oiling at 100–750 rpm, vacuum-fried chips typically finish at 13–20% oil.

Why de-oil under vacuum?

When a hot, porous chip leaves the oil, its pores are full of vapour at low pressure. If you break vacuum first, atmospheric pressure forces surface oil into those pores — oil uptake can more than double. Spinning before vacuum release throws surface oil off while the pores are still sealed by vapour pressure.

  • Drain: lift the basket out of oil and drain 30–60 s.
  • Spin: ramp to the target speed over 10–20 s to avoid breakage; our VF series run 100–750 rpm on variable-frequency drives.
  • Time: 1–3 minutes at speed for most fruit and vegetables.
  • Release vacuum: only after spinning stops.

Other factors that change oil content

FactorEffect
Slice thicknessThinner slices have more surface per kg → more oil
Pre-treatmentBlanching, sugar infusion and freezing change pore structure
Oil temperature80–100 °C is typical; too low lengthens frying and raises oil uptake
Vacuum levelDeeper vacuum (−0.098 MPa) lowers the boiling point and speeds drying
Oil qualityDegraded oil has higher viscosity and clings more — see oil washing

Equipment that makes it easy

Every LyoFry vacuum fryer integrates the frying basket, de-oiling drive and vacuum chamber, so the whole sequence — fry, lift, spin, release — runs automatically from the PLC recipe.

LyoFry Process Engineering Team

Engineers who design, build and commission freeze dryers and vacuum fryers at Shanghai Mars Industrial Co., Ltd., Shanghai.

Related Questions

What is the oil content of vacuum-fried chips?

With in-vacuum centrifugal de-oiling, typically 13–20% for the QS-VF150 and 15–20% for the QS-VF300, depending on product and slice thickness.

Can I add a separate centrifuge after frying?

You can, but de-oiling outside the vacuum is much less effective because oil has already been drawn into the pores. Integrated in-vacuum de-oiling is strongly recommended.

Start a project

Tell us what you make. We’ll engineer the line.

Send your product, daily output and voltage — we reply with a configuration and quotation within one business day.

WhatsApp

Get a Free Quote

Our engineers reply within one business day.